DPF cleaning machine sample management system first.
When operating the DCCS professional cutting tool AG cleaning machine for pipes, it can effectively remove traces of parasites falling from the pipes.
The cleaning operation speed adopts PID mode, and users can set multiple cleaning times. When cleaning 5 means to correct the cleaning operation, ultrasound is paused and the cleaning effect is ensured, allowing the complete removal of pipe and pipe residues without cleaning solution.
When selecting different cleaning agents, they can be uniquely combined with different process materials such as stainless steel, carbon steel, alloy steel, and cast steel, making their use more convenient.
Usually, 3 pairs of brushes are used for cleaning, and a single brush is used for about 15 minutes. The cleaning positions are all consistent and the cleaning effect is excellent.
According to different cleaning requirements, ultrasonic generators can be configured for different cleaning methods, such as oil removal, rust removal, wax removal, dust removal, wax removal, etc.
Different cleaning solvents require different cleaning solvents, the requirements for selecting cleaning solvents, and the durability required are different.
The cleaning tank must be filled with liquid before starting up and working. The minimum water level is>100mm (bottom vibration type) and placed horizontally. When the transducer is on the side, the cleaning tank should be located 100mm along the groove. If starting in air, it will damage the machine.
The cleaning fluid should not be strong acidic or alkaline, and liquid should not be used without reliable safety measures.
A certain amount of cleaning solution must be added to the cleaning tank, and liquid cannot be used.
For opaque cleaning fluids, if there is no specific aluminum cover, they must be replaced;
The cleaning machine must be placed in a dry and ventilated place, and the level between the cleaning tank and the cleaning tank should be less than 20cm to avoid collision with the cleaning tank.
At the beginning of cleaning, it is necessary to observe whether the movement direction of the machine is perpendicular to the ground. If the longitudinal area needs polishing or waxing.
At the end of cleaning, all switches of the machine should be placed in the “off” position to prevent damage to the machine due to water shortage.
After use, restart until the machine runs completely. After shutting down, the machine must be turned off first before restarting.
If this device encounters power outage issues, the above content can be considered.
When pressing the emergency button, the safety button must be pressed first, and then the electrical control box must be disconnected to clean the main unit.
Do not operate the equipment on your own in the cleaning room. You should first stop the power supply and wear protective glasses for protection.
When the machine is set to operate abnormally, the CP indicator light should be stopped and the power should be cut off. At the same time, when someone is operating the temperature controller, the item should be kept clean in a timely manner.
Generally speaking, it is best to use 5 types of sensors for ultrasonic cleaning machines, that is, when the required power supply is established in 2021, the ultrasonic control system should also be considered to adjust the constant power signal before starting use.